Plan a copper Cat6 Ethernet run by route, access, endpoint and test requirement. This page does not bundle optical fibre, mains power work or network configuration into a vague per-point promise.
A copper Ethernet data point is quoted after the route is reviewed because cable length, ceiling or wall access, termination method and testing drive the real scope. Send the point count, photos of both endpoints, the proposed route, property type and whether you want surface trunking or an existing conduit checked.
A point count alone cannot show access, route length or what must happen at the network end. The written quote should identify each of these items.
| Quote item | Confirm before booking | Why it changes scope |
|---|---|---|
| Route and access | Endpoint photos, approximate length, ceiling access, wall type and surface trunking or accessible conduit | Long routes, blocked conduits, high ceilings and restricted work areas change labour and materials. |
| Cable and endpoints | Copper Cat6 or Cat6A, point count, RJ45 faceplate, patch panel or direct network-end termination | The installed components should be specified as one compatible channel rather than assumed from the word “Cat6”. |
| Testing and handover | Basic continuity or wire-map test, labels, results handover and whether a formal certification report is required | A wire-map test and a standards-based certification report are different deliverables. |
| Site conditions | Property type, postal code, working hours, permits, fire-rated penetrations and building-management rules | Condominium, office and managed-building access can require approvals or specialist making good. |
The commercial scope is deliberately limited to copper Ethernet. IMDA states that its current telecommunication wiring class-licence framework applies to optical fibre cable installation and does not apply to copper-only installation. Fibre enquiries must therefore be separated and routed to a party with the applicable IMDA authorisation.
If the same job adds or relocates a power socket, modifies fixed mains wiring or changes a consumer control unit, that is separate electrical work. EMA says electrical installation, repair and modification work should be carried out or supervised by an appropriately licensed electrical worker.
Send the proposed outlet position and the router, switch or patch-panel location, plus a simple route sketch.
State whether surface trunking is acceptable and whether an existing conduit is known to be accessible.
Check cable category, termination, labels, testing, exclusions, access conditions and any making-good work in writing.
The written scope can include a copper Ethernet cable route, one or more RJ45 terminations, labels and a wire-map test. Trunking, patch-panel work, certification reports and making good are included only when they are listed in the quote.
No. This page covers copper Ethernet data points. Optical fibre installation is a separate scope and must be assigned to an installer or contractor with the applicable IMDA authorisation.
Copper Ethernet cabling by itself is not the same as mains electrical work. If the job also adds or relocates a power socket or changes fixed mains wiring, that electrical scope must be carried out or supervised by the appropriate EMA Licensed Electrical Worker.
No. A correctly terminated cable can provide the wired link specified in the quote, but actual speed also depends on the internet plan, router, switch, endpoint hardware, cable length and network configuration.
Share the point count, endpoint photos, route sketch, property type, access constraints and preferred finish. The reply can then separate cable, termination, testing and excluded works.