FAQ
Is your electrician licensed?
We arrange electrical work with EMA-licensed electricians where required. Share the job details and we will confirm the right setup for the scope.
Can you help with urgent power trips?
Yes. Send DB-board and affected-point photos with the address so we can review the fault and confirm the earliest safe slot.
Can you do HDB rewiring in Simpang?
Yes, we handle partial or full rewiring and ensure proper testing before handover.
Do you quote before starting?
Yes, we check onsite and confirm the final quote before any work begins.
What warranty do you provide?
EMA-regulated LEW work — DB-box, fixed wiring and water-heater hookup — is covered for 12 months under our
Warranty & Refund Policy. Non-regulated handyman-scope electrical work is covered for 90 days. Parts follow the manufacturer warranty.
Start Your Electrical Quote for Simpang
A couple of photos plus your Simpang postal code are enough for us to size up the electrical job and confirm the price with you first.
Typical Scope
These are the electrical jobs we most often handle in Simpang.
- Power trip / short-circuit troubleshooting
- DB box & circuit breaker checks
- Switch & socket replacement
- Add/relocate power points
Get a Clearer Quote Faster
Compare Quotes With These In Mind
- If you already expect rewiring or point shifting, mention it at the start.
- Share the DB board, affected switches/sockets and appliance load if possible.
Recent Example
Simpang Case 1: Old point replacement before move-in
Problem:A few switches and sockets were still usable but clearly aged.
Action:Swap the worn points, retest polarity and check the surrounding line condition.
Result:The room was safer and ready for handover use.
Site Proof Photos Before Quote
Real photos and short clips help us confirm access, measurements, materials and whether a site visit is needed before quoting this electrical service.
Photo reference
Compare real site condition, access points and visible constraints before booking the next step.
What to send first
Send a wide room view, close-up issue photos and the full address so the quotation can be checked faster.
Electrical Service Across Simpang
FixMove covers the whole of Simpang - including Pulau Seletar, Simpang North, Simpang South, Tanjong Irau. Older HDB blocks and newer condos sit side by side here, so unit access and servicing needs differ across the estate.
Share your block and nearest landmark when you WhatsApp us for a faster slot.
All FixMove services across Singapore
One team for plumbing, electrical, aircon, renovation, customization, handyman, installation and moving — island-wide.
Electrical Repair
Main islandwide page for this service. Useful when you want broader pricing, scope and coverage.
Renovation
Open this when rewiring, point shifting, kitchen upgrades or room-by-room electrical changes are becoming the real project.
Custom Built-ins
Useful when the electrical work is now tied to TV walls, built-ins, hidden cable routes or cabinetry planning.
Home Repair & Handyman
Drilling, lock replacement, mounting and mixed small works.
Plumbing Services
Toilet choke, leaking tap, pipe leak and water heater work.
Aircon Servicing
Not cold, leaking, chemical wash, gas checks and repair.
Installation Service
TV mount, curtains, appliances, racks and lock installation.
Moving Service
House moving, lorry, packing, dismantling and disposal coordination.
Simpang homes: what local housing means for a service visit
Simpang sits in Singapore's North Region near the Sembawang and Seletar coastline, spanning Pulau Seletar, Simpang North, Simpang South and Tanjong Irau. It is one of the island's least built-up planning areas: large stretches remain reserved land, coastal scrub and future-development plots, so the resident base today is small and scattered rather than a dense town grid.
Because there is no established MRT or large HDB cluster here yet, much of the lived-in housing leans toward low-rise and landed-style properties, scattered units and pockets close to the Sembawang and Springleaf fringes. Addressing falls under District 26 alongside Upper Thomson and Springleaf, which can sit some distance from the dwelling itself, so confirming the exact block or lot before a visit matters.
Access here is shaped by open, low-traffic roads and outlying plots rather than tight HDB carparks. The flip side is that some addresses sit off main routes, near greenery or coastal land, and signage can be sparse. Sharing a clear pin, gate details and the nearest landmark helps the visiting tradesperson reach the right door without circling.
- Confirm the precise neighbourhood (Pulau Seletar, Simpang North, Simpang South or Tanjong Irau) and a map pin, as plots here can be spread out and lightly signposted.
- For landed or low-rise homes, note gate access, the number of floors and how many rooms or units need attention so your technician arrives suitably equipped.
- Parking is usually open rather than multi-storey, but some addresses are off main roads; flag the access road and any private driveway in advance.
- Expect a mix of building ages and fittings across scattered properties, so mention whether the home is older or newer when describing the issue.
- With limited public transport into the area, allow a slightly wider arrival window for the visiting tradesperson and keep a contact number reachable on site.
Electrical jobs in Simpang: local access and booking notes
Simpang is a planning area in Singapore's North region, made up of 4 subzones. Addresses here fall under District 26 (Upper Thomson, Springleaf); the postal sectors mapped to that district are 77 and 78.
Electrical calls in this area split into two very different jobs: a fault at the fitting (one socket, one light, one appliance) and a fault behind the wall or at the distribution board. Knowing which one you have - does the whole home go dark, or only one circuit - changes what has to be brought to site.
What to send us about your electrical job in Simpang:
- Whether the whole home loses power or only one circuit, and what was running when it happened
- A photo of the distribution board with the cover open
- Whether the affected point is inside your unit or in a shared corridor, riser or meter position
- Your block or building number and full postal code, so we can place your address straight away